Advertisement
Quick Links
Model:
PRO 94 BT3
~
~
..c=? / ..==::- .!5"
TRANSMITTER
PROGRAMMING
GUIDE
The transmitters
included
with the security
system
have been pre -pro-
grammed
at the factory, with each button pre -assigned
to control a specific
function of the security system. Although the security system in the vehicle has
either 3 or 4 channels ( RECEIVER)
depending on the model, the transmitters
included with the system are 7 channel transmitters. This allows you to program
each transmitter
to more than one vehicle in two car families, and also allows
you to change which button ( s ) control certain functions of the system.
( Example:
Transmitter
channel 5 can be programmed
to activate Receiver
channel 2. ) Refer to the chart below for access to each of the transmitter
channels, and for the standard factory button assignments.
.
* Some of the more common accessories
for these additional channels are;
PROGRAMMING
THE TRANSMITTERS
It is important to remember that during programming,
each individual sb
the procedure
must be executed within 15 seconds of the previous stel=
When the 15 second time limit is allowed to expire, the system will au1or
cally tenninate
the programming
mode. This is indicated by a long chirp 1
the siren.
Additionally,
the system
will store codes from up to four different
transmit!
If a 5th
transmitter
is programmed
to any receiver
channel,
then
the
transmitter
programmed
to that
channel
will
be erased
from
the
systt
memory.
To program new or additional transmitters,
1. Enter the vehicle, and tum the ignition key to the" on" position.
2. Flip the valet switch on -off -on -off -on -then off.
3. The dash L.E.D. will flash one time, and the siren will chirp one time,
indicating
the system
is ready
to accept
programming
for receiver
channel
1.
4.
Press and hold the selected transmitter button ( s ) until the siren
sounds a long chirp, indicating the signal has been stored into memo
5.
If you have additional transmitters ( up to 4 ) that need to be pro-
grammed,
repeat step 4 for each transmitter.
6. Flip the valet switch on then off.
7. The dash
L.E.D.
will flash
two times,
and the siren
will chirp
two times,
indicating
the system
is ready
to accept
programming
for receiver
channel
2.
8. Press and hold the selected transmitter button ( s ) until the siren
sounds a long chirp, indicating the signal has been stored into memor:
9.
If you have additional transmitters
( up to 4 ) that need to be pro-
grammed,
repeat step 8 for each transmitter.
10. Flip the valet switch on then off.
AS 9151N
AS 9153
AS 9256
Remote car starter
Remote window roll up
Remote trunk release relay
)
128-4623
20F4
128-4623
1 OF 4
Advertisement
Related Manuals for Audiovox PRO94BT3
Summary of Contents for Audiovox PRO94BT3
- Page 1 ..c=? / ..==::- .!5" TRANSMITTER PROGRAMMING The transmitters included with the security grammed at the factory, with each button pre -assigned function of the security system. Although the security system in the vehicle has either 3 or 4 channels ( RECEIVER) depending on the model, the transmitters included with the system are 7 channel transmitters.
- Page 2 Include the appropriate 6. Method of payment; check one of the boxes below. Mastercard Visa Check or money .Make checks payable to Audiovox 7. Credit Card Number 8. Credit Card Expiration Date 9. Mail this form, and your check, to ;...