Page 1
TRANSMITTER PROGRAMMING GUIDE The transmitters included in the security system kit are pre-programmed at the factory, with button assignments (channels) prioritized in a standard format. Refer to the chart for standard factory configuration. Factory Settings for Transmitter Buttons BUTTON CHANNEL Button 1 Button 2 Both Buttons...
Page 2
These factory programmed settings can be prioritized based on an individual's frequency of use, (i.e. pressing both buttons simultaneously to activate channel 1, arm/disarm etc.) by following the normal programming instructions below. Please note when changing the button sequences of the factory settings, it is necessary to perform steps 5, 9, and 12 three times using "transmitter A", followed by one time using "transmitter B".
Page 3
10. Move the valet/bypass switch on, then off again. 11. The dash mounted L.E.D. will flash(*) 3 times, and the siren will "chirp"(*) one time, indicating that the system is ready to accept programming for channel 3. (PRO-9249R & PRO-9246R) 12.
Page 4
6. Method of payment; check one of the boxes below. Mastercard Visa Check or money order * (do not send cash) * Make checks payable to Audiovox Corporation 7. Credit Card Number : _____________________________________________ 8. Credit Card Expiration Date : _________________________ Credit card purchasers can order additional or replacement transmitters by phone.
Need help?
Do you have a question about the PRO94BT2 and is the answer not in the manual?
Questions and answers