Eliminating The Normal Arm / Disarm Chirps; Remote Panic Operation - Audiovox PRO9342FT3 Owner's Manual

ELIMINATING THE NORMAL ARM / DISARM CHIRPS

As explained earlier in the manual, you can eliminate the chirps selectively any time you arm
or disarm the system simply by holding the Lock/"Arm" / Unlock/"Disarm" button for two
seconds. If you find the normal arming and disarming chirps annoying, they can be turned
off permanently, eliminating the need to hold the Lock/"Arm" / Unlock/"Disarm" button for
two seconds. To do this,
1. With the valet switch in the off position, turn the ignition key on then off.
2. Within 10 seconds, move the valet switch to on then off three times.
3. If the chirps were on before you started, then you will hear 2 chirps indicating
they have been turned off.
If the chirps were off before you started, then you will hear one chirp indicating
they have been turned on.
NOTE: If the siren/horn chirps two times, regardless of the valet switch operation as
described above, then the horn and siren chirps have been turned off via programming
features 7 & 8. Contact your installation center or Audiovox technical department for
information on how to reinstate the chirp feature through programming.
NOTE: Whenever the chirps are by - passed, the 4 chirp intrusion indicator and 3 chirp
defective zone indicator will always operate. Since these are important warnings to you
that something has happened, they cannot be eliminated.

REMOTE PANIC OPERATION

The Lock/"Arm" / Unlock/"Disarm" button on your keychain transmitter also functions as a
panic switch for use in emergency situations. To use remote panic,
1. Press and hold the Lock/"Arm" / Unlock/"Disarm" button on the keychain
transmitter for 3 or more seconds. The alarm will immediately sound.
2. To stop the alarm, press and hold the Lock/"Arm" / Unlock/"Disarm" button on
the transmitter again for 3 seconds. If the button is not pressed, the alarm will
automatically stop after 30 seconds.
NOTE: All normal transmitter functions will operate in the panic mode.
ADDITIONAL REMOTE FUNCTION ( CHANNEL 2 )
This security system has an additional feature that can be connected to a number of
different optional accessories. Some of the more common uses for this channel are;
Remote Trunk Release
Remote Car Starter
Remote Window Closure
Remote Garage Door Interface
To activate the optional accessory, press and hold the option button 2 on the keychain
transmitter for 3 seconds.
Page 5