Audiovox Prestige P-99A Owner's Manual page 10

MANUAL UP/DOWN TUNING – See Main Unit
press to increase frequency, press
AUTOMATIC SEEK TUNING – See Main Unit
press to Seek upward, press
CD TRACK SELECT – See Main Unit
press to select a higher track number, press
a lower track number.
CD CUE/REVIEW – See Main Unit
for Cue function, press for Review function.
RADIO PRE-SET MEMORY 1 – See Main Unit
AUDIO SETTING MEMORY 1 (P1) - See Main Unit
DISC DOWN SELECT (D.DN) - See Main Unit
RADIO PRE-SET MEMORY 2 – See Main Unit
AUDIO SETTING MEMORY 2 (P2) - See Main Unit
DISC UP SELECT (D.UP) - See Main Unit
RADIO PRE-SET MEMORY 3 – See Main Unit
AUDIO SELECT MEMORY 3 (P3) - See Main Unit
CD PAUSE - See Main Unit
RADIO PRE-SET MEMORY 4 - See Main Unit
TRACK/DISC REPEAT (RPT) – See Main Unit
except
to decrease frequency.
except
to Seek downward.
and except
to select
and except press
and
and
-9-
RADIO PRE-SET MEMORY 5 – See Main Unit
TRACK/DISC SHUFFLE (SHF) – See Main Unit
RADIO PRE-SET MEMORY 6 – See Main Unit
TRACK/DISC SCAN (SCN) – See Main Unit
MODE SELECTOR (MOD) - See Main Unit
INFRARED SENDER
BATTERY COMPATRMENT
NOTES ON REMOTE CONTROL USE
1. The remote control operates on a 3-volt lithium battery (type
CR-2025). Install the battery into the compartment at the
bottom of the remote control, making sure to observe correct
polarity as shown in the diagram on the back of the control.
2. If the remote control fails to operate, always check battery
condition and replace if necessary before servicing the unit.
3. Dispose of used batteries properly. Do not heat, disassemble,
or throw used batteries into a fire.
4. Keep the remote control away from areas where it may be
exposed to direct heat, moisture, or sunlight.
and
and
and