VTech ES1500A Registration Instructions

Additional handset

ES1500A ADDITIONAL HANDSET REGISTRATION INSTRUCTIONS

This additional handset has been designed to operate with the ES1510A telephone system. Please refer to your

ES1510A user's manual for instructions on general functionality.

Package Contents

•

1 ES1500A handset

•

1 Charger

•

1 AC power adaptor

•

2 NiMH rechargeable batteries (for handset)

The position in which you place the ES1500A charger could have an effect on the range and performance of your

ES1500A.

Plug the mains power cable into the charger base, plug the other end into the mains power wall socket and switch

the power on.

NOTE

Ensure the power cord is fed through the slot on the charger so the unit sits ﬂush with the desk.

To ﬁt the NiMH battery into the handset, slide open the battery compartment cover. Place the supplied

rechargeable battery in the battery compartment, with the battery connector plugged in, as shown. Slide the

battery compartment cover back on until it clicks into place.

Place the handset on the charger to charge for at least 16 hours. A beep sounds when the handset is properly

placed on the base or charger.

Mains power wall socket

Mains power cable

Table of Contents

Do you have a question about the ES1500A and is the answer not in the manual?

Page 1 2 NiMH rechargeable batteries (for handset) Setting up your ES1500A Additional Handset The position in which you place the ES1500A charger could have an effect on the range and performance of your ES1500A. Plug the mains power cable into the charger base, plug the other end into the mains power wall socket and switch the power on.
Page 2 Registering an Additional Handset The additional handset must be registered to your ES1510A telephone base before use. Register your handset according to the following procedures. Register an additional handset through the menu Press and hold on the base station for about five seconds, the base station is entered into registration mode. Press to select REGISTRATION.