VTech FS2605A Quick Start Manual

FS2605A Additional Handset
Quick Start Guide

Package Contents

• FS2605A handset
• Charger with power adapter
• NiMH rechargeable battery pack

Connect the Charger

1. Plug the power adapter cable into the charger, plug the other end into the wall jack and switch the power on.
NOTE
• The distance in which you place the charger could have an effect on the range and performance of your FS2605A handset.

Install the battery

NOTE
• You can skip steps 1 and 2 for the first time you install the battery after you purchased this product, since the battery
compartment cover has already been separated.
1. Push the cover downward from the upper side.
2. Pull the cover outward from the lower side.
3. Insert the supplied battery pack into the battery compartment, observing the correct polarity.
4. Slide the battery cover back over the battery compartment until it clicks into place.
5. Put the handset on the base or charger to charge for at least 15 hours for the first time. A double beep sounds when
the handset is properly placed on the base or charger.
NOTE
• Use only the 2.4V NiMH rechargeable battery pack provide.
To wall power outlet

4
2
3