Advertisement
11. The dash mounted LED will flash 3 times, and the siren will "chirp"
indicating that the system is ready to accept programming for channel
3. (APS 350)
12. Press and hold the remaining transmitter button function. The siren will
emit a long "chirp" to confirm that programming of channel 3 was
successful.
13. To exit program mode, either turn the ignition key to the off position, or
move the valet switch on then off one additional time. This is indicated
by one short chirp then one long "chirp" from the siren.
NOTE: If programming to a Keyless Entry (non alarm) unit, there will be NO
chirp indication.
QUICK REFERENCE:
You can program any individual channel, without reprogramming all
channels, by following the quick reference chart below.
VALET SWITCH
CHANNEL
ON then OFF 3 Times
1
2
ON then OFF 4 Times
ON then OFF 5 Times
3
After the desired channel is programmed, turn the ignition key to the off
position to exit programming mode.
BATTERY REPLACEMENT:
The transmitter incorporates a small red LED built into the case. This LED
can be used to indicate battery condition. You will notice a decrease in
transmitter range as the battery condition deteriorates. To replace the
battery...
1. Remove the transmitter cover by removing the small screw from the back
of the transmitter case.
2. Remove the discharged battery, making note of the orientation of the +
and - contacts and dispose of the battery properly.
3. Install the new (type GP23A) battery, taking care to orient the + and -
contacts properly.
4. Replace the transmitter cover, taking care not to damage the LED or
switches on the circuit board.
LED
1 Flash
2 Flashes
3 Flashes
3
Advertisement
