Advertisement
exit chirp pattern. All transmitter buttons for that transmitter must now
be reprogrammed. Any other transmitter stored in the unit's memory still
remain operational. If the button is released and not pressed again
within the 5 second period, no change in programming has been made
to the receiver channel. The programmer can move onto a different
channel or erase the transmitter codes as described in 1 above.
QUICK REFERENCE CHART:
You can program any individual channel without reprogramming all
channels. To go directly to a particular receiver channel follow the
chart below:
CHANNEL
1 Ign. On Then
Press and Release 3 Times
2 Ign. On Then
Press and Release 4 Times
3 Ign. On Then
Press and Release 5 Times
4 Ign. On Then
Press and Release 6 Times
5 Ign. On Then
Press and Release 7 Times
6 Ign. On Then
Press and Release 8 Times
BATTERY REPLACEMENT:
The transmitter incorporates a small LED visible through the case which
is used to indicate battery condition. You will notice a decrease in
transmitter range as the battery condition deteriorates.
To replace the battery:
1) Remove the small # 0 phillips head screw from the rear of the case.
2) Remove the rear cover to access the discharged battery paying
attention to the proper polarity orientation.
3) Carefully remove and properly dispose of the discharged battery.
4) Insert the new battery, close the case, then reinstall the small case
screw removed in step 1.
5) If you accidently dislodge the circuit board from the transmitter
housing, be certain that the rubber
membrane is seated properly, and
the buttons are properly exposed
from the front view of the case, then
insert the circuit board and return
to step #4.
VALET SWITCH
5
LED
1 Flashes
2 Flashes
3 Flashes
4 Flashes
5 Flashes
6 Flashes
Advertisement
