Kernau KBW 172 D B Instruction Booklet page 26

HANDLE INSTALLATION
The handle is delivered in a separated package with
screws together inside the carton
To install handle to the door frame of the appliance:
① Reveal two small holes on the door frame from inner side
by pulling out a bit the door seal.
② Aim the handle to the holes and insert the screws from
inside.
③ Screw them up with screw-driver.
④ Put back door seal to cover the screws.
REVERSING THE DOOR
Our wine cooler is delivered with the door opening from left to right. To reverse the opening direction:
• Open the door at 90 degrees and keep it steady.
• Unscrew the two screws ① form the right lower hinge ② (Pic.1)
• Pull the door ⑤ outwards slowly (follw the arrow direction in Pic. 2), ato get off the lower hinge ②
and continue to pull the door ⑤ downwards slowly until getting off from the top right hinge ④ and
take off the lower hinge plate ③ f rom the door axis hole (Pic. 2).
• Screw off top right hinge ④ and right lower hinge ② from the housing ⑥ and keep them in the
polybag in case of possible reversing door in the future. (Pic. 3).
Pic. 1
Pic. 2
EN 26