Tecomec GEOline ORION Instruction Manual page 18

2.1 i o
dentifiCation
Please also refer to the Figs. 1 and 2 at the beginning of this use and maintenance manual.
1 Inlet connection
2 Setting lever
3
Delivery connections
4 By-pass connection
2.2 i P
dentifiCation
The identification plate (6) contains the main technical features of the control unit: Model, maximum
delivery, maximum pressure.
The identification plate is placed on the adjusting control unit body.
If during the use the identification plate becomes unreadable, apply to the dealer or to an authorised
service centre to get a new one.
3. i U
ntended se
The control unit is only intended for the following usages:
− treatment of agricultural and gardening crops;
− pumping of detergents and colours in water solution (not inflammable);
− pumping of water not for alimentary use.
The control unit is the necessary completion of the pump installed on the machine.
Therefore, all use limitations prescribed for the pump in the relevant use and maintenance manual
have to be observed also for the control unit .
Any other use is not allowed.
The Producer cannot be hold liable for possible damage resulting from unintended or wrong usages.
4. o
Peration
• The installation of the control unit must be carried out by a Skilled technician.
• Before using the control unit, carefully read the instructions of this manual, of the manual of the
connected pump and of the manual of the spraying machine. In particular, make sure you have fully
understood the liquid shutting-off operations of the control unit.
• Observe the safety warnings contained in the use and maintenance manual of the connected pump
and of the spraying machine.
• The control unit is the necessary completion of the pump installed on the machine.
Therefore, all use limitations prescribed for the pump in the relevant use and maintenance manual
have to be observed also for the control unit .
• Observe what mentioned in the paragraph "INTENDED USE".
• The working pressure must never overcome the maximum value prescribed for the control unit (see
18
C
f omPonents
late
Instruction Manual
5 Pressure gauge
6 Identification plate
7
Adjusting knob
CAUTION
CAUTION
CAUTION
ENG