Installation Instructions - ElectrIQ EIQMW20LSS Instruction Manual

INSTALLATION INSTRUCTIONS

Please Note - Electrical Connection
The oven is fitted with a plug and must only be connected to a properly
installed earthed socket. The socket must only be installed and the
connecting cable must only be replaced by a qualified electrician, and in
accordance with the appropriate regulations. If the plug is no longer
accessible following installation, an all-pole isolating switch must be
present on the installation side with a contact gap of at least 3mm.
1. Select a level surface that provides enough open space for the
vents. Blocking the vents may cause damage to the oven.
2. The minimum installation height is 85cm
3. The rear surface of the oven should be placed against a wall.
Leave a minimum clearance of 30cm above the oven, and a
minimum of 20 cm to both sides.
4. Do not remove the legs from the underside of the oven.
5. Place the oven as far away as possible from radios and TV's, as
operation of the oven may cause interference to their reception.
6. Plug your oven into a standard household outlet. Be sure the
voltage and frequency are the same as on the rating label.
30CM
0CM
20CM
MIN
85CM
WARNING: Do not install the oven over a cooking surface or heat
producing appliance. If installed near or over a heat source, the oven
could be damaged and the warranty would be void.
The accessible surface may be hot during operation
20CM
8