Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Moneris Move 5000
Summary of Contents for Moneris Move 5000
- Page 1 Moneris Core® Wireless Move/5000 Setting up Your Hardware (Oct 2019)
-
Page 2: Table Of Contents
Using the charge-only base ..........................5 Using the direct-to-terminal charge cable ......................6 Battery use ..............................8 Helpful hints ............................... 8 Battery status indicators............................. 8 Power on ................................8 Power off ................................8 Merchant support ............................9 Moneris Core® Move/5000 Terminal: Setting up Your Hardware... -
Page 3: Before You Get Started
1. Confirm you have received the required hardware. Direct-to-terminal power cable Move/5000 terminal Optional charge-only base Paper roll Power cable for charge base 2. Go to Hardware setup on page 3. Moneris Core® Move/5000 Wireless Terminal: Setting up Your Hardware... -
Page 4: Hardware Setup
3. Unroll enough paper to extend at least one inch (2.5 cm) over the top of the lid. Note: If the paper is installed backward, your printouts will be blank. Continued on the next page… Moneris Core® Move/5000 Wireless Terminal: Setting up Your Hardware... -
Page 5: Power On The Terminal
Note: You may need to connect the terminal’s power cable in order to power it on. Refer to the instructions in Charging the battery on page 5 for your setup type (direct-to-terminal charge cable or optional charge base). Moneris Core® Move/5000 Wireless Terminal: Setting up Your Hardware... -
Page 6: Charging The Battery
Important: You must use the exact power adaptor and cables provided by Moneris to work with the Moneris Move/5000 terminal and base. Failure to do so may affect the operability of, or cause damage to, the equipment. -
Page 7: Using The Direct-To-Terminal Charge Cable
6. When the terminal powers on, proceed to step 6 on page 7. Using the direct-to-terminal charge cable 1. Locate the direct-to-terminal charge cable. 2. Locate the power port on the left side of the terminal (marked with the power symbol ( Moneris Core® Move/5000 Wireless Terminal: Setting up Your Hardware... - Page 8 9. Keep the direct-to-terminal charge cable (or the optional base charge cable) connected while continuing the rest of the setup procedures. 10. Your hardware setup is complete. To set up your software and communications, refer to the Moneris Core® Move/5000 Setting up Your Software guide available at moneris.com/support-move5000.
-
Page 9: Battery Use
Press and hold the green key until the screen illuminates. Power off Press and hold down the punctuation key, then press the yellow key until the terminal begins to power off. Moneris Core® Move/5000 Wireless Terminal: Setting up Your Hardware... -
Page 10: Merchant Support
Visit moneris.com/support-move5000 download additional copies of this guide and other resources; consult the Moneris Move/5000 Online Manual in WebHelp format to understand all the options on your terminal and how to use them Visit shop.moneris.com to purchase point-of-sale supplies and receipt paper ... - Page 11 All other marks or registered trade-marks are the property of their respective owners. © 2019 Moneris Solutions Corporation, 3300 Bloor Street West, Toronto, Ontario, M8X 2X2. All Rights Reserved. This document shall not wholly or in part, in any form or by any means, electronic, mechanical, including photocopying, be reproduced or transmitted without the authorized consent of Moneris Solutions Corporation.
Need help?
Do you have a question about the Move 5000 and is the answer not in the manual?
Questions and answers