Hoisting - SPX Marley LW032 B Series User Manual

receiving and hoisting

Hoisting

All LW fluid cooler models use reinforced hoisting clips located near the air
inlet (bottom section) of the equipment for overhead lifting and handling of
assembled shipping modules. A spreader bar should always be used at the top
of the unit to help balance the load and prevent damage to the top section —
consult the applicable hoisting instructions drawing. Never use hoisting clips
located near the top of the equipment to lift the entire unit, as these are
intended for lifting subassemblies only during factory assembly. If a forklift
is used to lift from the base of the equipment, ensure forks extend completely
underneath the unit and past the basin flange on the opposite side. Remove
fluid cooler from the trailer and hoist into place according to the instructions.
Fluid coolers must be hoisted and set according to instructions.
Warning
Under no circumstances should you use hoisting clips located near
the top of the equipment to lift the entire unit.
Hoisting clips are provided for ease of unloading and positioning
Warning
the fluid cooler. For overhead lifts or where additional hazards exist,
safety slings should also be placed under the unit.
5