HMS Premium SW7200 Manual page 12

Step 2 Slide the vertical seat post (pt. 10) into the seat post
housing on the main frame (pt. 16). Then slide the Sliding Tube
(pt. 12) into the Vertical Seat Post (pt. 10), then secure using a flat
washer 1 (20) and L Shape knob (19). You will have to slacken the
knurled section of the L Shape knob (pt. 19) and pull the knob
back and then select the desired height. Release the knob and
retighten the knurled prtion.
Now fix the Seat (pt. 13) to the Sliding Tube (pt. 12) as down and
tighten the bolts around the screws under the seat.
Step 3 Slide the handlebar post (pt. 17) into the handlebar post
housing on th main frame (pt. 16). You will have to slacken the
knurled section of the L shape Knob (pt. 19) and pull the knob back
and then the desired height. Preleade the knob and retighten the
knurled portion. Then fix the handlebar (pt. 18) with a flat washer 1
(20) and L shape knob (19).
Attention: you should fix the handlebar tightly.
Install the console (76) into the suport tube of the handlebar (18).
Connect the sensor wire (A1&A2).
Step 4 The Pedals (pt.1 L & pt.1 R) are marked "L" and "R" - Left
and Right.
Connect them to their appropriate crank arms. The right crank
arm is on the right- hand side of the cycle as you sit on it.
Note that the Right pedal should be threaded on clockwise and
the Left pedal anticlockwise.