Spray Nozzle; Checking Spark Plug; Repairing Leaking Connections; Air Filter - Ford FPWG2700H-J-EU Operating Manual

34 SPRAY NOZZLE

If a pulsing sensation is felt while squeezing the trigger, the spray nozzle may be dirty or clogged
and should be cleaned immediately.
To clean the nozzle, shut off the engine and turn off the water.

Remove the nozzle from the spray wand making sure that the nozzle is pointing away from

you and in a safe direction.
Use the nozzle cleaner or a small paper clip to dislodge any foreign materials which are

clogging or restricting the spray tip.
Flush debris out of the nozzle by back flushing with a garden hose for 30-60 seconds.

Reconnect the nozzle to the spray wand.

Turn the water supply back on and start engine.


35 CHECKING SPARK PLUG

Disconnect the spark plug wire from the spark plug.

Before removing the spark plug, clean the area around its base to prevent debris from entering

the engine.
Clean carbon deposits off the electrode with a wire brush.

Check the electrode gap and slowly adjust to 0.80 mm (0.031 in.) if necessary.

Reinstall spark plug and tighten to Torque 22.0 – 26.9 Nm (16-20 ft-lb).

Reconnect spark plug wire.

If spark plug is worn replace only with an equivalent replacement part. Spark plug should be

replaced annually
WARNING! Water pressure produced by this unit can cut through skin and tissue
leading to serious injury and possible amputation.
Never attempt to repair high pressure hose, always replace.

Never attempt to repair leaks with sealant, always replace O-ring or seal.


36 REPAIRING LEAKING CONNECTIONS

Purchase O-Ring / Maintenance kits through the nearest authorized service centre and follow

instructions provided with kit.

37 AIR FILTER

A dirty air filter will reduce the life span of the engine, make starting the engine more difficult and
reduce the unit's performance.
To clean, remove the air filter cover.

Carefully pull the air filter out by lifting up along the edges.

Remove dirt from filter by tapping on it or having it blown out.

Reinstall air filter so that it seals and reposition air filter cover.

WARNING! Storage cover could be flammable.
pressure washer.
Copyright © 2016
FPWG2700H-J-EU / FPWG3100H-J-EU
P a g e
Let engine cool before covering
| 19 www.fordpowerequipment.co.uk
EN
Nozzle cleaner