Related Manuals for Ford FPWG3100H-J
Summary of Contents for Ford FPWG3100H-J
- Page 1 Model: FPWG3100H-J Gasoline Pressure Washer OPERATOR’S MANUAL Warning: The Engine Exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. www.fordpower.cc...
-
Page 2: Table Of Contents
TABLE OF CONTENTS Introduction....................................3 Safety Rules .....................................4 Safety Symbols ................................4 Safety Instructions ...............................4 Pressure Washer Features ..............................7 Pressure Washer Parts Assembly............................8 Pressure Washer Parts List ..............................9 Assembly ....................................10 Packing List ................................10 Unpacking ...................................10 Attaching Wheels ..............................11 Attaching Foot Assembly............................11 Raising Handle................................11 Attaching Upper and Lower Gun Hooks ........................12 Attaching High Pressure Hose Hook ..........................12 Attaching Accessory Hook ............................12... -
Page 3: Introduction
FORD POWER EQUIPMENT continually seeks advancement in product design and quality. Therefore, while this manual contains the most current product information available at the time of printing, there may be minor discrepancies between your product and this manual. If there is any question concerning this manual, please consult a FORD POWER EQUIPMENT dealer. -
Page 4: Safety Rules
SAFETY RULES Safety Symbols Indicates a potentially hazardous situation which could WARNING! result in serious injury or death if not avoided. Indicates a potentially hazardous situation which could CAUTION! result in damage to equipment or property. Slippery surface Risk of fire Risk of explosion Risk of electric shock Hot surface... - Page 5 SAFETY RULES To reduce the risk of injection, injury or possible amputation, never direct water pressure WARNING! towards people or pets. • The high pressure stream of water produced can cut through skin and underlying tissue. Never squeeze the trigger or point the spray gun at other people, animals, plants, or fragile objects such as glass, even if the engine is stopped.
- Page 6 • To avoid recoil, pull starter cord slowly until resistance is felt, then pull rapidly. Never operate this unit if there are any broken or missing parts and only use Ford Power WARNING! Equipment replacement parts specifically designed for this unit.
-
Page 7: Pressure Washer Features
PRESSURE WASHER FEATURES A - Five Quick-Connect Spray Tips I - Locking Trigger B - Fuel Tank and cap J - Pull Cord C - Choke K - Engine On/Off Switch D - Fuel Valve Lever L - Oil Fill and Dipstick E - Soap Tank M - No Flat Foam Filled Tires F - Handle... -
Page 8: Pressure Washer Parts Assembly
PRESSURE WASHER PARTS ASSEMBLY... -
Page 9: Pressure Washer Parts List
PRESSURE WASHER PARTS LIST NUMBER ITEM NAME 208CC Engine Selector Knob Screw, Self Tapping O-Ring Valve Spool O-Ring Valve Body Screw, Self Tapping Cap, Soap Tank B Cap, Soap Tank A Panel, Soap Tank M6 Lock Nut M6 Screw Soap Tank A Screw, Self-Tapping Soap Tank B Siphon Tube... -
Page 10: Assembly
ASSEMBLY Packing List • Pressure washer • Quick start guide • Operator’s manual and product registration card • Spray gun • Extension wand with quick-connect fitting • High pressure hose • Spray nozzles (5) - 0°, 15°, 25°, 40° and soap nozzle •... -
Page 11: Attaching Wheels
ASSEMBLY Attaching Wheel Assembly (See fig 1) • Parts needed - 2 hair pins, 2 wheels, 2 axles, 2 hub caps and 2 self-tapping screws. • Slide the wheel axle pin through hole located in the center of the wheel. •... -
Page 12: Attaching Upper And Lower Gun Hooks
ASSEMBLY Attaching Upper and Lower Gun Hooks (See fig 3) • Attach the upper and lower gun hooks. • Install two M6 screws & the lock nuts, wrench tighten until the nuts are snug. Attaching High Pressure Hose Hook (See fig 4) •... -
Page 13: Adding Engine Oil And Fuel
ASSEMBLY Adding / Checking Engine Oil (See fig 7) • Place pressure washer on a level surface. • Remove one or both of the crankcase dipsticks to ensure you do not overfill the engine. • Carefully add 520 ml (17.6 oz) of 4-Cycle engine oil (SAE10W30) to empty reservoir until oil reaches the outer edge of the oil fill hole (Crankcase Dipstick hole). - Page 14 ASSEMBLY Connecting Garden Hose to Pressure Washer (See fig 9) • Run water through the hose for a few seconds to flush any debris from the hose. • Inspect inlet screen and remove any debris. • Connect hose to water inlet and tighten by hand. There must be a minimum of 10 feet of unrestricted hose between pressure washer and faucet or shut off valve.
-
Page 15: Operation
OPERATION Pre-Operation Check List • Read and understand this operator manual in its entirety before operating pressure washer. • Check oil level and add oil to the proper level if low. • Check fuel level and add fuel if needed. •... -
Page 16: How To Turn Off Pressure Washer
OPERATION Risk of Injection or Injury – Do Not Direct Discharge Stream At Persons. WARNING! This pressure washer is equipped with a thermal relief valve (TRV). The TRV is a temperature actuated valve that will open and allow cool water to pass from the garden hose through the pump head to cool the head if the pump reaches 140°F. -
Page 17: Using Spray Nozzle
OPERATION Using Spray Nozzle (See fig 16) • To connect or disconnect spray tip, pull back on the quick-connect collar. Insert or remove spray tip then release collar. • When spray tip is connected, pull on the spray tip to make sure it is secured. •... -
Page 18: Maintenance
MAINTENANCE Regular maintenance will extend the life of this pressure washer and improve its performance. The warranty does not cover items that result from operator negligence, misuse, or abuse. To receive full value from the warranty, operator must maintain the pressure washer as instructed in this manual, including proper storage. Follow the maintenance instructions specified in the manual. -
Page 19: Changing Engine Oil
MAINTENANCE Risk of injury. If the pressure washer is equipped with a battery, disconnect the battery CAUTION! ground wire before servicing. Changing Engine Oil Engine oil will drain better if the engine is still warm, but not hot. • Shut off engine. •... -
Page 20: How To Store
MAINTENANCE • Flush debris out of the nozzle by back flushing with a garden hose for 30-60 seconds. • Reconnect the nozzle to the spray wand. Nozzle Cleaner • Turn the water supply back on and start engine. Checking Spark Plug •... -
Page 21: Troubleshooting
TROUBLESHOOTING PROBLEM CAUSE SOLUTION Engine does not start 1. Out of fuel 1. Fill fuel tank 2. Engine oil low 2. Add engine oil 3. Spark plug wire disconnected 3. Connect spark plug wire from spark plug 4. Replace spark plug 4. -
Page 22: Warranty
From the date of original purchase, Ford Power Equipment warrants to the original purchaser, that each pressure washer sold, shall be free from defect in material and workmanship, for the items and time period set forth below. Ford Power Equipment, at its discretion, agrees to repair or replace any defective part that upon examination, inspection, and testing by a Ford Power Equipment authorized service dealer, is found to be detective within the original warranty period. - Page 23 Where Warranty is Valid: – For warranty coverage, this product must be purchased from Venus Tools, the authorized Ford Power Equipment distributor and the warranty only extends to the original purchaser. Refurbished, used, demonstration, or floor models are not covered by this warranty. Products purchased from on-line auction websites, such as ebay, are not covered under this warranty.
Need help?
Do you have a question about the FPWG3100H-J and is the answer not in the manual?
Questions and answers