Using Spray Nozzle (See Fig. 16); Applying Detergent; Rinsing With The Pressure Washer; Moving The Pressure Washer - Ford FPWG2700H-J-EU Operating Manual

21 USING SPRAY NOZZLE (SEE FIG. 16)

To connect or disconnect spray tip, pull back on the quick-

connect collar. Insert or remove spray tip then release collar.
When spray tip is connected, pull on the spray tip to make sure

it is secured.
For general cleaning use the 40° spray tip. This option is for

cement walkways.
For stripping, spot cleaning, blasting, and hard to reach areas

use the 25° spray tip. This option is for removing paint, rust,
mildew, marine growth off boats, or grease stains. This option
can be used for reaching second story surfaces, or for the
removal of paint, rust, oil stains, tar, gum, and other stubborn
substances. Use extreme caution when using this nozzle.
For applying pressure washer safe detergent, use the black soap

nozzle.
WARNING! Risk of injection or severe injury – Keep clear of nozzle – Do not direct
discharge stream at persons – This product is to be used only by trained operator.

22 APPLYING DETERGENT

Rinse surface with cool water before applying cleaner.

Prepare detergent as required by job. For best results follow detergent directions as supplied

from manufacturer.
Remove cap from detergent container and fill.

Spray detergent on surface. For best results use long, even, and overlapping strokes. Allow

detergent to set for about 3 minutes before rinsing, but do not allow detergent to dry on
surface or it may cause streaking or cause damage to the surface. Use good judgment.
To clean equipment after use, flush water through the spray nozzle for 1-2 minutes then shut

off engine. Soak nozzle in a bucket of clean water to remove detergent.
WARING! Only use detergents or soaps that are safe to be used with pressure
washers. Chemicals which are caustic, such as acids or bleach, can result in
serious injury, property damage, or death.

23 RINSING WITH THE PRESSURE WASHER

Test a small area first to avoid surface damage.

Rinse from top to bottom using long, overlapping strokes.


24 MOVING THE PRESSURE WASHER

Turn the pressure washer off.

Tilt unit towards you until it is balanced on its wheels.

Roll machine to desired location.

WARNING! Do not overreach or stand on unstable support. Keep good footing and
balance at all times.
WARNING! Keep operating area clear of all persons.
Copyright © 2016
FPWG2700H-J-EU / FPWG3100H-J-EU
P a g e
Fig. 16
| 16 www.fordpowerequipment.co.uk
EN
Spray wand
Nozzle