Table of Contents
Advertisement
Figure 12
1. Self-propel-drive bar
Note:
The maximum self-propel-drive speed is
fixed. To reduce the speed, increase the space
between the self-propel-drive bar and the handle.
•
To disengage the self-propel-drive, release the
self-propel drive bar.
Note:
To reduce the ground speed, increase the
space between the self-propel drive bar and the
handle.
Bagging the Clippings
Use the grass bag when you want to collect grass and leaf clippings from the lawn.
WARNING
A worn grass bag could allow small stones and other similar debris to be thrown toward you
or bystanders, resulting in serious personal injury or death.
Check the grass bag frequently. If it is damaged, install a new Toro replacement bag.
WARNING
The blade is sharp; contacting the blade can result in serious personal injury.
Shut off the engine and wait for all moving parts to stop before leaving the operating position.
Installing the Grass Bag
1.
Lift up the rear deflector (A of
2.
Insert the rod ends of the grass bag into the notches in the handle brackets (B of
3.
Allow the rear deflector to rest on the bag.
Shutting Off the Engine
To shut off the engine, release the blade-control bar.
Note:
when you leave the machine.
Important:
bar, the engine should shut off and the blade
should stop within 3 seconds. If they do not, stop
g240765
using your machine immediately and contact an
Authorized Service Dealer.
Mulching the Clippings
Your machine comes from the factory ready to mulch
the grass and leaf clippings back into the lawn.
If the grass bag is on the machine, remove it before
mulching the clippings. Refer to
Bag (page
Figure
13).
Figure 13
12
Remove the key (if equipped) from the ignition
When you release the blade-control
13).
Figure
Removing the Grass
13).
g240796
Advertisement
Table of Contents
