Care And Maintenance; Cleaning The Filters; Leaving The Machine Unused For Extended Periods - Hotpoint Ariston LL 430 Instruction Booklet

Table of Contents

Advertisement

Available languages

Available languages

Care and maintenance

Turn off the water tap after every wash cycle to avoid
leaks.
Remove the plug from the socket when cleaning the
machine and when carrying out maintenance work.
The external surfaces of the machine and the control
panel may be cleaned using a cloth dampened with
warm soapy water. Do not use solvents or abrasive
products.
Any marks on the appliance interior may be removed
using a cloth dampened with water and a little
vinegar.
Always keep the door of the appliance ajar in order
to avoid moisture from forming and being trapped
inside the machine.
Clean the seals around the door and detergent
dispensers regularly using a damp sponge. This will
avoid food becoming trapped in the seals, which is
the main cause of the formation of unpleasant
odours.
Food residue may become
encrusted onto the sprayer
arms and block the holes
used to spray the water. It is
therefore recommended that
the arms are checked from
time to time and cleaned with
a small non-metallic brush.

Cleaning the filters

The filters remove food residue from the water used in
the wash cycle: to obtain the best results from each
wash, they should be cleaned.
Clean the filters regularly.
After cleaning check that the filter assembly has
been replaced correctly.
The dishwasher should not be used without filters or
when the filter is loose..
1. Remove the filters by pulling the handle upwards.
2. Clean the filters:
• The entire filter assembly
should be cleaned thoroughly
once a month: this includes
the semicircular plate A, the
glass B and the cylinder C
(this may be removed by
turning it in an anti-clockwise
direction). Use a small non-
metallic brush to clean these parts.
3. Reconstruct the filter assembly and replace it in the
correct position, following movements 1 and 2 as shown
in the figure, until it clicks into place.
Leaving the machine unused for
extended periods
Disconnect the appliance from the electricity supply
and shut off the water tap.
Leave the door of the appliance ajar.
• When you return, run a wash cycle when the
dishwasher is empty.
• after every wash cycle,
remove the largest pieces
of residue from
semicircular plate A and
glass B (these may be
removed by pulling the
handle) by rinsing them
under running water.
21
EN

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ll430fr

Table of Contents