Hussmann microSC MDN-BA Installation & Operation Manual page 7

1-2 INSTALLATION
LOCATION (Continued)
Product should always be maintained at proper
temperature . This means that from the time
the product is received, through storage,
preparation and display, the temperature of the
product must be controlled to maximize the life
of the product .
be sure to position self contained
merchandisers properly
SELF CONTAINED models have vented base
panels to allow air circulation through the
condensing unit .
Allow for a minimum of 2 inches of clearance
from walls, merchandisers, and any other large
objects near the merchandiser's vented base
panels . A minimum space of 2 inches should
be left above the case . Blocking or restricting
air flow will adversely affect performance and
may damage the refrigeration system .
If the merchandiser is used or stored in a hot
spring or coastal area, it may be damaged (due
to sulfur or salt) . If the intention is to install
the merchandiser in any of the above areas or
locations, contact the supplier or dealer where
you purchased the merchandiser . Do not lay
the case sideways to move the case . This may
cause damage . Case should be installed on a
flat, level floor .
After installation, fix the case in place with the
leveling legs (case option) to make sure that it
does not move. Or if the case has casters, lock
the casters.
Leveling Legs or Casters
P/N 9FQ-6-P110-075-00_B
.
Do not block this inlet
or the merchandiser
will not cool properly
U.S. & Canada 1-800-922-1919 • Mexico 01 800-890-2900 • www.hussmann.com
Hanging
Wall
2-inch gap
required
(51 mm)
Floor
CAUTION
!
WARNING
!
NOTICE
Do not store items or flammable
materials atop the unit.
IMPORTANT
STOP
Air inlet
DANGER
!
Wall
2-inch gap
required
(51 mm)
2-inch
STOP
Air Exhaust
Clearance
from Wall
Ground wire
(Optional)
ATTENTION
INSTALLER