Optional Equipment; Disconnecting The Battery; Pre-Installation - Jensen VM9413 Installation Manual

Optional Equipment

• NAV102: Allows you to access navigation features. All installation and operating instructions are included
with the navigation module.
• BTM10: Allows you to connect to a Bluetooth enabled cell phone or other device.
• Rear Camera
• CNP2000UC and CNPJEN1 (XM Radio tuner and antenna)

Disconnecting the Battery

To prevent a short circuit, be sure to turn off the ignition and remove the negative (-) battery cable prior to in-
stallation.
NOTE: If the VM9413 is to be installed in a car equipped with an on-board drive or navigation computer, do
not disconnect the battery cable. If the cable is disconnected, the computer memory may be lost. Under these
conditions, use extra caution during installation to avoid causing a short circuit.

Pre-installation

Remove the four screws that attach the mounting sleeve to the
1
radio and remove the sleeve.
Install the mounting sleeve.
2
a. Install mounting sleeve into the dashboard or optional
adapter. Do not force the sleeve into the opening or cause
it to bend or bow.
b. Locate the series of bend-tabs along the top, bottom and
sides of the mounting sleeve. With the sleeve fully insert-
ed into the dashboard opening, bend as many of the tabs
outward as necessary so that the sleeve is fi rmly secured
to the dashboard.
c. Install support strap to make the unit more stable.
Place the radio in front of the dashboard opening so the wiring
3
can be brought through the mounting sleeve.
CAUTION! Be careful not to damage the car wiring.
TAB
2
TAB
DASHBOARD
DASHBOARD