Priming The Pump; Burner Start-Up Cycle - Riello G 24 Installation, Use And Maintenance Instructions

Light oil burner

Hide thumbs Also See for G 24:

Table of Contents

6. PRIMING THE PUMP

In case of a gravity feed system, from the bottom of the oil-storage tank (see page 4), loosen the screw of the

suction-gauge fixing point 3 (Fig. 1), until the fuel flows out.

In the other two cases, start the burner and bleed the air from the pressure gauge connection by loosening

plug 4 (Fig. 1).

Do not illuminate the photoresistance as this would cause an immediate lock-out.

If, during these operations, the burner locks out, reset it and repeat the cycle as many times as necessary.

CAUTION!

Check, before starting the burner, that the return line to the oil-storage tank is not in any way obstructed.

Any obstruction would cause the breakage of the pump seals.

THERMOSTAT

MOTOR

IGNITION TRANSFORMER

VALVE

LOCK-OUT LAMP

NORMAL

LOCK-OUT BECAUSE NO IGNITION

Table of Contents

3473000