Table of Contents
Advertisement
Available languages
Available languages
If a problem should develop while operating the CD player, the following error codes may be displayed on
the LCD panel.
ER-1: Indicates an error in the microprocessor control of the CD player. Eject the disc, make sure it is
clean, undamaged, and loaded correctly (label side up). Re-load the disc and check for proper
operation or try another disc. You may also try activating the Re-Set button
will also erase the time and pre-set memories.
ER-2: Indicates a mechanism error or that the disc is not loading or ejecting properly. Try re-loading or
pressing the Eject button again.
ER-3: Indicates excessive temperature conditions. CD play will resume when the temperature returns to
the normal range.
If the suggested measures do not solve the problem, contact an approved warranty station near you for
further assistance.
Size:
178 mm x 50 mm x 163 mm
Operating Voltage:
12 volts DC, negative ground
Output Power:
120 watts maximum
( 30 watts x 4 channels)
Output Wiring:
Floating-ground type designed for 4 speaker use.
Front and rear channels CANNOT be combined (bridged) for use with2 speakers.
RCA low-level outputs (rear channels).
Output Impedance:
Compatible with 4-8 ohm speakers.
Low-Level Output:
2.0 volts (2,000 mv.)
Tuning Range:
AM: 530-1,720 KHz. (10 KHz. step)
522-1,620 KHz. (9 KHz. step)
FM: 87.5-107.9 MHz. (200 KHz. step)
87.5-108.0 MHz. (100 KHz. step)
Sensitivity:
AM: 20 uv.
FM: 1.5 uv.
FM Stereo Separation:
30 dB
CD Frequency Response: 20-20,000 Hz. ±1 dB
CD Signal/Noise Ratio:
70 dB
CD Channel Separation: 60 dB
CD Distortion:
0.2%
*Specifications are subject to change without notice.
This unit is supplied pre-set at the factory for reception of North American radio stations (10 KHz. channel
spacing on AM/200 KHz. spacing on FM). Use in other areas in the world may require different channel
spacing. A switch on the bottom of the chassis allows selection of 9 KHz. AM/100 KHz. FM channel spacing.
Slide the switch to the appropriate position using a small screwdriver blade. The Re-Set button
front of the chassis must then be pressed to activate the change of channel spacing.
ERROR CODES
ERROR CODES
ERROR CODES
ERROR CODES
ERROR CODES
SPECIFICATIONS
SPECIFICATIONS
SPECIFICATIONS
SPECIFICATIONS
SPECIFICATIONS
7" W x
2" H x 6-3/8" D
FREQUENCY STEP SWITCH
FREQUENCY STEP SWITCH
FREQUENCY STEP SWITCH
FREQUENCY STEP SWITCH
FREQUENCY STEP SWITCH
cr
on the unit, but this
cr
on the
10 10
10 10
10
Advertisement
Table of Contents
