Audiovox ACD-26 Owner's Manual page 6

OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS
1
ON/OFF POWER BUTTON
Press this button to turn the unit on or off. If the
ignition switch is "on" the unit will also turn on
automatically when a compact disc is inserted or
when any front panel button is pushed.
2
VOLUME / LEVEL CONTROL
To increase the volume level, press the
The volume will increase and the level will be shown
on the display panel from a minimum of "VOL 00" to
a maximum of "VOL 63". To increase the volume
quickly, keep the button pressed. To decrease the
volume level, press the
pressed to decrease the volume quickly. The display
will automatically return to the normal indication
5 seconds after the last volume adjustment or when
another function is activated. These buttons are also
used in conjunction with the Select button
the bass, treble, balance, and fader levels as described
4 5 6 7
in , , and .
3
SELECT BUTTON (SEL)
CONFIRMATION TONE SELECTOR (
This button is used to select the audio function
(volume, treble, bass, balance, or fade) to be adjusted
using the Level Control
button once will set the unit for volume adjustment
("VOL" will appear on the display panel). Pressing
the button additional times will select treble ("TRE"
on the display), bass ("BAS"), balance ("BAL"),
5 5 5 5 5
fader ("FAD") or volume ("VOL"). The display
button.
button. Keep the button
3
to adjust
)
2
. Pressing the Select
will automatically return to the normal indication
5 seconds after the last adjustment or when another
function is activated.
Pressing and holding the button for longer than
2 seconds will activate the Confirming Tone feature
as indicated by two beep tones and the
appearing on the display panel. When activated,
the unit will produce a single beep tone whenever a
momentary press function is activated and two beep
tones whenever a press-and-hold function is activated
(ie. Auto-Store Tuning, etc.). To deactivate this
feature, press the button again for longer than
2 seconds ( the indication will disappear from
the display panel).
4
TREBLE CONTROL
To adjust the treble level, first select the Treble mode
by pressing the Select button
indication appears on the display panel. Within 5
seconds of choosing the Treble mode, press the
or button of the Level Control
the treble response as desired. The treble level will
be shown on the display panel from a minimum of
-7 to a maximum of +7 (0 is flat response). The
display will automatically return to the normal indication
5 seconds after the last adjustment or when another
function is activated.
5
BASS CONTROL
To adjust the bass level, first select the Bass mode
by pressing the Select button
indication
3
so that the "TRE"
2
to adjust
3
so that the "BAS"