Related Manuals for Ingersoll-Rand MULTI-VANE 1800 Series
Summary of Contents for Ingersoll-Rand MULTI-VANE 1800 Series
- Page 1 Form P5901 Edition 9 December 2005 CCN 03524014 MULTI-VANE MOTORS ® 1800 Series Operations and Maintenance Information Save These Instructions...
- Page 2 Do not lubricate motor with flammable or volatile liquids such as kerosene, diesel or jet fuel. • Do not remove any labels. Replace any damaged label. • Use accessories recommended by Ingersoll-Rand. • This motor is not designed for working in explosive atmospheres. •...
- Page 3 Grease leakage from the spindle end is also Filter-Regulator-Lubricator Unit. Keep the Lubricator filled an indication that an excessive amount of grease has with Ingersoll-Rand No. 50 Oil. These units have 3/8” pipe accumulated within the Gear Case. tap inlet and outlet.
-
Page 4: Operation Of Motor
Operation of Motor (Dwg. TPB176) 03524014_ed9... - Page 5 Notes 03524014_ed9...
- Page 6 1800 Series Exploded Diagram. (Dwg. TPB183-1) 03524014_ed9...
- Page 7 1800 Series Parts List Part Part Description Description Number Number 1 Air Strainer (1 for Series 1801: Rotor Pinion (for Model 1801P or 2 for Series 1841) R18-465A 1841P) R1801P-17 2 Backhead Gear Head for Series 1801 R1801-102 for Model 1801P or 1841P R1801P-216 for Series 1841 R1841-102...
-
Page 8: Maintenance Section
1800 Series Parts List (continued) Spindle 34 Spindle Planet Gear (3) for Model 1801N or 1841N for Model 1801N or 1841N (5/8” round shaft) R1801N-108 (21 teeth) R1801U-10 for Model 1801P, 1801Q, for Model 1801P, 1801Q, 1801U, 1841P, 1841Q or 1801U, 1841P, 1841Q or 1841U 1841U (17 teeth) -
Page 9: General Instructions
6. For all Models except 1801N or 1841N, if the Gear 10. Using a bearing puller, pull the Spindle Front Bearing (37) Head Planet Gear Bearing or Bushings (24) must be off the front hub of the Spindle. replaced, press them from the Planet Gears. 11. - Page 10 12. For all Models except 1801N or 1841N, stand and 8. Push the Rear Rotor Bearing (8) onto the short hub of the support the assembled Gear Head on the table of an Rotor against the Rear End Plate and install the Rear arbor press with the spline shaft end downward and Rotor Bearing Retainer (7) in the groove on the shaft of press the Gear Head Bearing (22) onto the hub of the...
- Page 11 Notes 03524014_ed9...
- Page 12 Ingersoll-Rand © 2005 Company...
Need help?
Do you have a question about the MULTI-VANE 1800 Series and is the answer not in the manual?
Questions and answers