Table of Contents
Advertisement
EN
2 Installation
2.1 Overview
SeaWays and SeaWays GO are integrated autopilot systems. SeaWays
builds off of an Optimus EPS or Optimus 360 system by adding a GPS and
heading sensor. The system uses position and heading data to steer the
vessel automatically.
The SeaWays GPS sensor allows Heading, Track, and Route modes
whereas the SeaWays GO compass allows Heading mode. For more
information on the three modes of operation, please refer to section 3.
Once your Optimus EPS or Optimus 360 system is installed, adding
SeaWays is simple:
1. Install the SeaWays or SeaWays GO sensor
2. Route network cable from sensor to Optimus network backbone
3. Apply Sensor license provided with kit (captured on back cover
of this booklet)
4. SeaWays commissioning
2.2 Before you begin
Before installing sensor:
1. Optimus EPS or Optimus 360 must be fully installed and commissioned
2. All software must be up to date – See book 65 for instructions on
updating software
2-1
Advertisement
Table of Contents
