Table of Contents
Advertisement
2-12
Use the supplied mounting kit, including the mounting template, and drill holes.
NOTICE!
Never mount the compass upside down! Level the sensor as close to
horizontal as possible.
Sensor Dimensions
Figure 2-14 illustrates the physical dimensions of the SeaWays GO sensor.
1.42"
Figure 2-14. SeaWays GO Precision 9 sensor dimensions.
Calibrating the SeaWays GO sensor
2.5.2
The compass calibrates itself automatically while the boat is turning in a circle.
Dometic recommends that a calibration procedure is completed during the
sea trial manually by performing 2 consecutive 360° turns within 5 minutes
after power is applied to the compass.
It is also possible, but not required, to perform a calibration with an approved
Simrad multi-function display. Using this method please refer to Navico/
Simrad documentation.
3.54"
4.69"
Ø1/4"
MOUNTING HOLE
2 PLACES
EN
Advertisement
Table of Contents
