Table of Contents
Advertisement
EN
Pole mount
2.4.7
Figure 2-9: Sensor, with pole mount adapter.
Pole mounting the sensor
1. Choose a location that meets the mounting location requirements.
2. Mark and drill the mounting holes as necessary for the threaded pole.
3. Thread the jam nut loosely onto the 1 inch pole, then thread the
pole mount.
4. Thread the communication cable through the hollow pole or through
the opening in the pole mount and connect to the SeaWays sensor.
5. Secure the pole mount to the SeaWays sensor using the supplied
mounting hardware. Tighten to a torque of 8–10 lbs-ft. The maximum
thread depth must be no more than .5 in.
6. Verify the orientation of the unit, then tighten the jam nut to the
bottom of the pole mount to a torque of 8–19 lbs-ft.
WARNING!
Over-tightening may damage the system. Do not tighten the pole mount
to more than 4 lbs-ft.
2-9
Advertisement
Table of Contents
