Table of Contents
Advertisement
Commissioning
Sub Parameter
Parameter
Options
Enable Override
Mode
Show XTE Limits
Table 2-4.
EN
3. An option also exist to reset SeaWays user options to default.
Figure 2-29.
Settable
Range
Yes/No
Yes/No
NOTE
Only Enable Override Mode parameter is applicable for SeaWays
GO system.
2.8.3
Sea trial
When using an autopilot:
• Do not leave the helm unattended
• Verify the course and position of the vessel at regular intervals
• Always switch to Standby mode, and reduce speed in sufficient time
to avoid hazardous situations
WARNING!
Always wear a PFD and connect the engine lanyard(s) to the operator during
sea trial.
An autopilot is a useful navigational aid, but DOES NOT under any
circumstances replace a human navigator.
WARNING!
Do not use automatic steering when:
• At extreme speed
• In heavy traffic areas or in narrow waters
• In poor visibility or extreme sea conditions
• When in areas where use of autopilot is prohibited by law
Default
Procedure/Description
Value
Yes
When set to "No", turning the helm in heading or
track modes causes the autopilot to disengage.
When set to "Yes", Override mode is entered when
helm is turned
Yes
When set to "Yes", XTE limits are displayed on track
and route screens
2-21
Advertisement
Table of Contents
