Bradley SXWS9561 Installation Manual

Read this entire installation manual to ensure proper installation. When finished
Installation
with the installation, file this manual with the owner or maintenance department.
Compliance and conformity to local codes and ordinances is the responsibility of
the installer.
Separate parts from packaging and make sure all parts are accounted for before
Packing List
discarding any packaging material. If any parts are missing, do not begin
IS
T H
E
S ID installation until you obtain the missing parts.
U P
Before installing components, all connection supply lines must be flushed and
free of foreign material such as pipe dope, chips, solder, etc. Bradley will not be
responsible for leaking valves due to the presence of foreign material, or
distorted stop gaskets where excessive pressure (above 30 lbs. of torque) has
been applied to the stop cap.
After flushing has been completed, make sure that all water supply lines have
been completely turned off before beginning installation. After installation has
been completed, turn the water supply lines back on and test the unit for leaks
and adequate water flow.
Product warranties may be found under "Product Information" on our web site at
www.bradleycorp.com.
215-960 Rev. B; EN 05-714
© 2005 Bradley Corporation
Page 1 of 6 11/11/05
Installation
SXWS9561
Stainless Steel Panel Shower

Table of Contents

Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Wall Openings (no soap dish) . . . . . . . . . . . . . . .2
Wall Openings (recessed dish) . . . . . . . . . . . . . . .3
Wall Openings (surface-mount soap dish) . . . . . .3
Installation - Shower Components . . . . . . . . . . . .4
Installation - Optional Soap Dish . . . . . . . . . . . .5
Cleaning Stainless Steel . . . . . . . . . . . . . . . . . . . .6
WARNING
P.O. Box 309, Menomonee Falls, WI 53052-0309
Phone: 1-800-BRADLEY Fax: (262) 251-5817
http:\\www.bradleycorp.com