Connector Configuration; At Power Connector - QDI P6I440LX/L6 Manual

Chapter 2

Connector Configuration

This section lists all connector pins assignment and port descriptions
on the motherboard. The particular state of the connectors and ports
are illustrated in the following figures. Before inserting these
connectors, please pay attention to the directions.
AT Power Connector ( J24 )
PIN NUMBER
1
2
3
4
5
6
7
8
9
10
11
12
ATX Power Connector(J20) & Power Switch (Power)
The power switch should be connected to a momentary switch only when ATX Power
Supply is used.
1. When powering up your system, turn on the mechanical switch of the ATX power
supply first, then push once the button of the momentary switch.
2. If you want to power off your system, you need not turn off the mechanical switch of
the ATX power supply,
switch(POWER). The location of connector is as shown in the figure below:
POWER
FUNCTION
POWER GOOD
+5V
+12V
-12V
GND
GND
GND
GND
-5V
+5V
+5V
+5V
push once* again the button of the momentary

AT POWER CONNECTOR

ATX POWER CONNECTOR
Chapter 2
2 - 1