Siemens KGF Series User Manual page 30

en
Appliance is not cooling,
temperature display and
lighting are lit up.
The side panels of the
appliance are warm.
Freezer compartment door
was open for a long time;
temperature is no longer
reached.
Automatic super freezing
does not switch on.
The following settings are
switched off:
Audible signals
■
Interior lighting
■
Messages on the display
■
panel
Automatic super freezing
■
The background illumination
of the display panel is
reduced.
Buttons are locked.
30
Showroom mode is switched
on.
The side panels contain
pipes which heat up during
the cooling process.
The evaporator (refrigeration
generator) in the NoFrost
system is covered in thick ice
and can no longer be
defrosted fully automatically.
Sabbath mode is switched
on.
Press and hold °C button and @ setting button
for 5 seconds until a confirmation tone sounds.
Another confirmation tone sounds when the
buttons are released.
After a short time, check whether your
appliance is cooling.
That is normal behaviour for the appliance and
not a fault.
Furniture touching the appliance will not be
damaged by the heat.
To defrost the evaporator, remove the frozen
food with the compartments, insulate well and
store in a cool location.
Switch off the appliance and move it away
from the wall. Leave the appliance door open.
After approx. 20 min. the condensation begins
to run into the evaporation pan, at the rear of
the appliance.
To prevent the evaporation pan from
overflowing in this case, mop up
the condensation with a sponge.
The evaporator is defrosted when the
condensation stops running into the
evaporation pan. Clean the inside. Switch the
appliance back on again.
The appliance decides independently whether
automatic super freezing is required and
automatically switches it on or off.
Press the super button for 15 seconds.