Advertisement
1814 S / ARC QUICK REFERENCE GUIDE
The quick reference guide is not a substitute for the Operators Manual!
Please refer to Operators Manual for more detailed information
TRACTOR CONNECTION (ARC)
1. Hydraulics
Red pipe
> Supply (50 lpm)
Blue pipe
> Return (Free flow return!!)
2. Electrics
A. Connect 12V supply to 3pin plug
B. Connect wrapper harness to controller
C. Connect receiver to controller
ENTERING THE WORKING POSITION
1. Lower the rear of the machine to the ground
and adjust the hydraulic jack until the
machine is level.
2. Remove the transport bracket and lower the
unloading conveyor to the ground.
3. Adjust the working width of the rollers to
suit the size of bale being used.
Lock the rocking rollers in
place using the pin.
4. Install the roll of film and attach the film to
the Cut & Start.
3
B
A
1
2
4
Advertisement
Table of Contents
Related Manuals for Tanco 1814 S
Summary of Contents for Tanco 1814 S
- Page 1 1814 S / ARC QUICK REFERENCE GUIDE The quick reference guide is not a substitute for the Operators Manual! Please refer to Operators Manual for more detailed information TRACTOR CONNECTION (ARC) 1. Hydraulics Red pipe > Supply (50 lpm) Blue pipe >...
- Page 2 OPERATION Start the engine to activate the hydraulic system (S model only). Place a bale on the wrapping table. With the controller set to “Auto Mode”, press “Auto Start” on the remote (a) or on the controller (b). The wrapping cycle will then begin.
- Page 3 EXPERT CONTROLLER OPERATION - Current No. of wraps 4-way Menu switch: - Target No. of wraps Set no. Of wraps - Wrapping speed (RPM) Change/Reset Bale Sub-Total - Bale total Access Operator Setup Menu - Grand total No. of bales Access Technician Setup Menu - Mode: Manual /Auto Pause wrapping (A)
- Page 4 AUXILIARY CONTROL VALVES Used for lowering the machine to the ground in preparation for wrapping. Used for adjusting hydraulic jack at drawbar. This is necessary for levelling the machine prior to wrapping. Used for adjusting the width of the rocking rollers when changing to different size bales.
Need help?
Do you have a question about the 1814 S and is the answer not in the manual?
Questions and answers