Advertisement
OPERATION
1.
Start the engine to activate the
hydraulic system (S model only).
2.
Place a bale on the wrapping
table.
3.
With the controller set to "Auto
Mode", press "Auto Start" on the
remote (a) or on the controller (b).
The wrapping cycle will then
begin.
Once the target number of wraps
is reached, the film will be cut
and wrapping will stop.
4.
If "Auto Unload" is activated in
the Operator Settings, the bale
will be automatically unloaded
onto the conveyor once wrapping
is complete.
5.
If "Auto Unload" is not selected,
the bale can be unloaded by
pressing "Tip" (c) on the remote
or by pressing "Bale unload" (d)
on the controller.
a
b
c
d
Advertisement
