Husqvarna PP 492 Operator's Manual page 11

Main menu Submenu
4. "SET GEAR"
5. "SET DRIVE
MODE"
6. "SET ROT. DIR."
1. "DRIVE
CHOICES"
7. "SET FUSE"
8. "SET WATER
VALVE"
967 - 002 - 11.06.2021
Adjustment
The connected wall saw has 2 mechanical gears:
1. (600-900 rpm)
2. (800-1200 rpm)
Set the necessary "DRIVE MODE" for the product:
• "BLADE MAN" for wall sawing
• "BLADE STD" for wall sawing
• "WIRE" for wire cutting
• "CHAIN" for chain sawing
Stop the product before change of direction of the blade. Select be-
tween:
• "STANDARD"
• "REVERSE"
To use full power output, the product must be connected to a 32 A fuse.
With a fuse that is lower rated, the power output must be lower to not
overload the fuse. Select the applicable fuse rated value that is related to
the connected product:
• 16A
• 25A
• 32A
The water flow is adjusted with the ball valve at the water connector inlet.
Select correct water regulation:
• "ON" - The water valve is always open.
• "AUTO" - The water valve opens when the dial is turned from its
closed position.
11