Husqvarna PP 492 Operator's Manual page 12

Main menu Submenu
9. "RUN TIME"
10. "TIME & DATE"
11. "LANGUAGE"
2. "SETTINGS"
12. "SET UNITS"
13. "PAIR RADIO"
14. "RADIO CHAN-
NEL"
3. "SERVICE"
15. "CALIBRATE ARM"
16. "SET BLADE DIAMETER"
Radio communication system
Before you can operate the connected power tool, you
must do a pairing operation between the remote control
and the product.
The remote control can only control the connected
product.
If the supplied remote control is replaced, you must do a
pairing operation between the remote control and the
product again.
If it is necessary to interchange the remote controls
between 2 power pack units, you must do a pairing
operation between the interchanged remote control and
the product.
12
Adjustment
• "TIME COUNTER" - A stop monitor counts the time that the blade or
the wire rotates during the operation when minimum 1 supply is on.
• "CLEAR RUNTIME" - Releases the stop monitor.
• "CURRENT RUNTIME" - Shows the current run time.
• "SET TIME" - Set the current time.
• "SET DATE" - Set the current date.
• "TIME FORMAT" - Select time format:
• 12h
• 24h
• "DATE FORMAT" - Select date format:
• "YYYY-MM-DD"
• "YYYY/DD/MM"
• "DD/MM/YYYY"
Select display language.
Select unit for the remote control:
• "AMERICAN"
• "METRIC"
Connect the remote control with the product.
If there is interference or loss of signal, the radio channel for the remote
control and the product must be changed. To set up the radio channel,
the remote control must be connected to the product with a CAN bus ca-
ble. Select the correct radio channel:
• 0 (2.410 GHz)
• 1 (2.415 GHz)
• ...
• 11 (2.465 GHz)
The "SERVICE" menu is locked by password. Only servicing personnel
have access to do the adjustment in the "SERVICE" menu.
The calibrate menu is used to calibrate the position of the pivot arm. Use
the position of the pivot arm to calculate the current depth of the blade.
The blade diameter adjustment is used to calculate the depth of the
blade.
To do a pairing operation between the remote
control and the product
1. Connect the remote control to the product with the
supplied CAN bus cable.
2. Tighten the cable connector screws by hand.
967 - 002 - 11.06.2021