Subscribe to Our Youtube Channel
Related Manuals for Associated Electrics RC10L2 Road Series
Summary of Contents for Associated Electrics RC10L2 Road Series
-
Page 14: Final Adjustments
FINAL ADJUSTMENTS MAKE THESE ADJUSTMENTS BEFORE RACING screw first, then tighten the opposite screw the SETTING THE TWEAK 2 Scribe the centerline at the front of the chassis same amount. with your hobby knife. We set the “tweak” after EVERYTHING ex- 3 To tweak the car, place the tip of a hobby knife cept the body is installed on the car, including bat- on the center mark as shown. -
Page 15: Maintenance
BATTERY CHARGING & Associated recommends the use of a good DISCHARGING. To maintain performance quality automatic peak detection type charger. Peak from your battery packs, it is recommended you DISCHARGING detection chargers will automatically sense when completely discharge them between charges. There The battery packs used for R/C cars are six- the battery pack is fully charged and shut off, thus are several inexpensive discharges available at your... - Page 16 CASTER CHANGE The 0° mount is level with the chassis when mounted. The 10° mount is angled 10° in relation to the chassis or lower suspension arm. This angle REAR provides a change in caster during suspension movement. The caster angle will change two de- grees during full suspension travel.
- Page 17 DAMPENER PLATE MAINTENANCE the least aggressive for steering during hard cornering. WARNING! You must pay very close attention to tire diameter when using either of the roll stop It is very important to keep the dampener plates CLEAN and lubed for inserts.
Need help?
Do you have a question about the RC10L2 Road Series and is the answer not in the manual?
Questions and answers