Reconfiguring The Gateway; Static Ip - TEKTELIC Communications Kona Micro Gateway Quick Start Manual

4 Reconfiguring the Gateway

4.1 Static IP

Gateway is setup to use DHCP by default. A static IP can be assigned manually through Kona FT.
1. Connect KonaFT to the gateway usin the IP assigned via DHCP
2. Open the Miscellaneous tab in KonaFT (Board Details ->Misc)
3. Set a valid IP address, IP mask and Gateway in the network configuration section
4. After verifying the values entered, press the set button to apply the change to the GW
Note: It is not recommended to edit the interfaces file directly through the terminal as there is
a risk of making the unit inaccessible through the network interface.
Kona Micro Quick Start Guide
TEKTELIC Communications Inc.
Figure 8: Static IP cofigurtaion
T0005281_QS
Confidential
Version 0.2
Page 13 of 16