Operation - Triplett CFM100 User Manual

1.800.544.2843

Operation

Connecting the Vane
1. The vane plug is inserted in the meter's sensor jack at the top of the
meter. The plug and jack are keyed so that the plug can only fit in the jack
one way.
2. Turn the plug carefully until it lines up with the jack and then firmly push
the plug in place. Do not apply undue force or try to twist the plug side-to-
side.
3. If the vane is not connected to the meter or if the sensor is defective, the
LCD display will indicate OL in place of a Temperature reading.
Air Velocity Measurements (Single Point)
1. Turn on the meter using the ON/OFF
2. Press UNITS button to select the desired unit
of measure. NOTE: At power up the meter will
display the last unit of measure previously
entered.
3. Place the sensor in the air stream. Ensure that
the air enters the vane as indicated by the
arrow sticker placed inside the vane.
4. View the readings on the LCD Display. The
large main LCD display shows the Air Velocity
reading. The upper right LCD sub-display
shows the temperature reading.
www.calcert.com
15
10 20
5 25
0 30
Side view of Vane
button.
Arrow
airflow
sales@calcert.com