Table of Contents
Advertisement
PcPlug-R
Connect the
female connector.
PcPlug-R
The
DB-9 female connector pin assignment is as follows:
PcPlug-R
The
power plug is a 2.1mm connector for a DC 5-12V supply (positive inside). Max 15V.
Current is < 60 mA.
This section provides a quick guide to perform basic measurements with the PcPlug-R Sensor.
9.1- Get Started:
To start measurements simply follow this list of actions:
1- Insert the RS-232 connector into the PC port.
2- Run Serial Terminal SW or your own SW
3- Set the personal instrument settings:
Select the Measurement Range, Zero the instrument, and choose between the Power or Energy measurement
mode. For detailed instructions please
document.
4- Verify the set wavelength:
Select the laser wavelength.
5- Zero the instrument:
Resetting the zero value is a recommended action every time a PcPlug-R Sensor is used.
For detailed instructions please
6-Start the measurement session:
Place the detector head in front to the laser source. The measured Power/Energy values will be promptly
displayed on the instrument screen.
LaserPoint srl – PcPlug-R Laser Power and Energy Meter - All Rights Reserved
7-
INSTALLATION
electronics to the host PC device by a 9-pin, straight through, RS-232 cable with
8-
QUICK GUIDE TO MEASUREMENT
refer to the "PcPlug-R - RS-232 Communication Interface"
refer to the "PcPlug-R - RS-232 Communication Interface" document.
6 -
Advertisement
Table of Contents
