Related Manuals for Larzep HEP0250
Summary of Contents for Larzep HEP0250
- Page 1 INSTRUCTIONS & MAINTENANCE SHEET ELECTRIC TEST PUMPS HEP0250 LARZEP, S.A. Avenida Urtiaga, 6 48269 Mallabia, Spain Tel. +34 943 171200 Fax. +34 943 174166 e‐mail: info@larzep.com www.larzep.com V01.2019 ...
- Page 2 Instructions and Maintenance Sheets Electric Test Pump “HEP0250” DECLARATION OF CONFORMITY 2 ...
- Page 3 Please note that if the equipment is disassembled or serviced by anyone other than an authorized service dealer or by LARZEP, S.A., this guarantee is rendered null and void. In the event of a warranty claim, return the equipment to LARZEP, S.A. or the authorized dealer which sold you the hydraulic equipment. LARZEP, S.A. will repair or replace the faulty equipment, whichever is deemed most appropriate. LARZEP, S.A. shall not be held liable for any consequential damages or losses, which may occur as a result of faulty equipment. BEFORE USING THE EQUIPMENT AND ESSENTIAL SAFETY REQUIREMENTS ...
- Page 4 Instructions and Maintenance Sheets Electric Test Pump “HEP0250” ASSEMBLY AND OPERATING INSTRUCTIONS The components are shipped unassembled to prevent breakage or unnecessary bulk during transport or the stockage in warehouse. Before starting operations, check if the pump has been labelled with serial number and technical data. Keep package for further transports or stockage. Ensure that all the equipment and accessories The pump must always be handled are suitable for the maximum working pressure. and repaired by qualified personnel. Assemble the device in accordance with the next procedure, first checking that you have all the necessary material. Use PTFE tape on all threads to prevent any leakage. Before starting any operation, clean the tank to eliminate any residue or waste. To avoid pressure oscillation due to air in the system, it is necessary to purge the air circuit to fill the system completely. 1. Assembly all components. The pump is provided with a pressure gauge and control valve. ...
- Page 5 Instructions and Maintenance Sheets Electric Test Pump “HEP0250” Replace the seals at least every two years. Change oil after 50 working hours first time, and then, every 500 working hours. Use mineral oil SAE30. This maintenance timing can change with harder working conditions. TROUBLE SHOOTING ‐ Pump does not reach the desired pressure: check in order: suction filter, air in the pump, pressure valves, inlet connections, seals. ‐ Pressure change continuously: check the presence of air bubbles in the circuit, check the presence of dirt, the ...
Need help?
Do you have a question about the HEP0250 and is the answer not in the manual?
Questions and answers