Led On / Off; Encryption Code Set; Adjusting The Encryption Code - Zaxcom RX-4 User Manual

Zaxcom RX-4

LED On / Off

LEDS:
ON
This menu toggles on / off the receiver LED's.

Encryption Code Set

ID1: 000
The encryption menu is where the encryption is turned on and the code is set. The encryption code needs to
match the encryption code of the associated transmitters. If an encryption code is set on the transmitter the
transmitted audio will be encrypted and can only be listened to if the RX-4 has the same matching encryption
code entered. When the codes do not match, all that will be heard is white noise.
These two sets of numbers are formed into a single six-digit encryption code which provides a total of
16,777,216 possible combinations. For non-encrypted operations all six numbers should be set to 0.
Encryption can be set independently for each receiver side.

Adjusting the encryption code

Press the RECEIVER key to advance to the desired character.
1.
To change the designated character, press the INC or DEC key.
2.
Press the MENU key to exit.
3.
ID0: 000
10
Extended Menu