ATTO Technology R30F Installation And Operation Manual page 29

Problem configuring Mode Pages for this drive!
Unconfigurable pages will be left unchanged.
Some mode page settings of the selected drives
did not match the expected settings. To prevent
any damage or corruption, these unrecognized
settings will not be changed. Please report the
model of this drive to ATTO Technology
Technical Support so that its mode page settings
can be added to future versions of ExpressRAID.
Can't install driver to disk! There is not enough room
unless the disk is repartitioned.
You have attempted to use the Install Driver
option to put the ExpressRAID driver on a
volume. Unfortunately the driver partition created
by the previous formatting software was not large
enough for the ExpressRAID driver. This volume
must be erased and re-partitioned for the
ExpressRAID driver to be used.
Re-initializing the drive will erase all data on the
disk.
Error writing driver to disk!
ExpressRAID was unable to successfully write its
driver to the volume selected. Replace the cable,
verify correct termination, turn the drive off and
back on, and restart your computer. If this does
not help, re-initialize the disk.
Re-initializing the drive will erase all data on the
disk.
Driver was installed to disk successfully! It will take
control of the drive the next time you restart the
system.
The Install Driver command was successfully
completed. The drive will continue to use the old
driver, if there is one, until the system is restarted.
After restart, the drive will use the ExpressRAID
driver and will be represented on the desktop by
an ExpressRAID icon.
Program aborting because the Macintosh OS SCSI
Manager 4.3 cannot be accessed! In order to run the
program, please ensure that your System Software is
up to date, intact and includes SCSI Manager 4.3.
ExpressRAID requires Apple's SCSI Manager
4.3 to operate. SCSI Manager 4.3 is built into
every Power Macintosh and the Quadra 840AV.
Other Macintosh compatible systems require
SCSI Manager to be loaded using the SCSI
Manager 4.3 extension included with the
operating system.
Drive's block size is 0! The drive may need to be low-
level formatted.
Click the Rescan button. If this message
reappears, the drive appears to be damaged or
corrupted, and may need to be formatted. Before
formatting the drive, try replacing the cable,
verifying correct termination, turning the drive off
and back on and restarting your computer.
Unrecoverable error accessing drive.
Click the Rescan button. If this message
reappears, ExpressRAID was unable to
successfully communicate with the selected drive.
Try replacing the cable, verifying correct
termination, turning the drive off and back on, and
restarting your computer.
Error formatting drive.
Click the Rescan button. If this message still
comes up, ExpressRAID was unable to format the
selected drive. The drive may be defective. Try
replacing the cable, verifying correct termination,
turning the drive off and back on and restarting
your computer.
24