ZIGBEE 70100003 Quick Start Manual

ZigBee Wireless CCT Remote
Important: Read All Instructions Prior to Installation
Function introduction
Press and hold down to search and pair to ZigBee network
or factory reset the dimmer switch
Click to turn on the paired
lighting devices
Brightness button, press
and hold down to
increase/decrease light
intensity
11 mm
Battery: CR2450
Before the first use, please open the battery
cover and remove the protective film
Click to turn off the paired
lighting devices
CCT color button, press
and hold down to adjust
color temperature
Note: This switch
supports 1 group for
binding max. 30 lighting
devices.
Front side
71.20 mm
55.57 mm
Back side
Product Data
70100003
Protocol
Operation Voltage
Transmission Frequency
Transmission Range (free field)
Protection Type
Dimming Range
Dimensions
16.ZigBee Clusters Supported by This Remote Are As Follows:
Input clusters:
• Basic • Power Configuration
Output clusters:
• Identify • On/off • Level control
Safety & Warnings
• This device contains a button lithium battery that shall be stored and disposed properly.
• DO NOT expose the device to moisture.
Quick Start (Simplified operation compared to standard operations in the part "Operation")
Factory reset: click both buttons
3 times to factory reset the
remote (the remote should
already be paired to a gateway).
• ZigBee CCT remote based on ZigBee 3.0
ZigBee 3.0
• Enables to pair ZigBee lighting devices via touchlink
3VDC (CR2450)
commissioning without coordinator
• Supports find and bind mode to pair with ZigBee
2.4GHz
lighting devices
30m
• Supports 1 group for binding max. 30 lighting devices
• 2.4 GHz global operation
IP20
• Long battery life mesh technology
0.1%-100%
• Transmission range up to 30m
• Compatible with universal ZigBee Gateway products
71.2x71.2x13.6mm
• Compatible with universal CCT ZigBee lighting
devices
• Identify • Diagnostics
• Ota • Color control
Network pairing mode: click both buttons 3 times to
set the remote into network pairing mode (the remote
should not belong to any gateway network).
Touchlink: Press and hold
down both for 3 seconds to
start touchlink and link light
device to the remote.