Advertisement
Quick Links
SZ-BSW01 ZigBee Binary Switch Installation Guide
SZ-BSW01 can provide "smart" lighting remote control with its embedded radio frequency (RF) technology that is compatible
with ZigBee enabled devices. This device is designed to give you one-touch control of your home's lighting.
In a ZigBee network, each device is designed to act as a router. These routers will re-transmit the RF signal from one device to
another until the signal is received by the final destination. Using RF technology ensures SerComm to provide great signal through
all the obstacles and radio dead spots. The plug-in Lamp Module of SZ-BSW01 is compatible with any ZigBee enabled network,
regardless of the manufacturer and can also be used with other devices with the ZigBee logo.
CAUTION: Remember to have common sense while using the remote control, especially when scheduling unattended devices.
There can be some unexpected consequences if used without care. For example, if an empty coffee pot is remotely turned on, and
your coffee pot could be damaged from overheating. Or if an electric heater is turned on by remote control while clothing is
draped over it, it may result a fire. DO NOT USE the remote for controlling the high power heating appliances such as portable
heaters. This device will not control lighting used with electronic low-voltage and high frequency power supply transformers, nor
high pressure discharge lamps (HID lighting), which include mercury-vapor, sodium vapor and metal halide lamps. DO NOT
change location after unit is enrolled in ZigBee network.
Specification
Rado Frequency
RF Communication Range
LED Indicator
Power Source
Output Max Current
Dimensions (H x W x D)
Operation Temperature
Storage Temperature
Package Contents
Warnings and Cautions
To be installed and/or used in accordance with appropriate electrical codes and regulations.
If you are unsure about any part of these instructions, please consult a qualified electrician.
2.4GHz
Open Aire：100M (Max)
Red / Greed LED x 1
Input：120 VAC, 0.5A, 50-60 Hz
10A
55 mm x 55 mm x 38 mm (2.15" x 2.15" x 1.48")
0° - 50°C (32° - 122°F)
-20° - 70°C (-4° - 158°F)
1
Advertisement
Related Manuals for ZIGBEE SZ-BSW01
Summary of Contents for ZIGBEE SZ-BSW01
-
Page 1: Package Contents
ZigBee enabled devices. This device is designed to give you one-touch control of your home's lighting. In a ZigBee network, each device is designed to act as a router. These routers will re-transmit the RF signal from one device to another until the signal is received by the final destination. - Page 2 The LED will be on for 1 seconds when join/leave function is succeeded and then off Installation NOTE: In order to use SZ-BSW01 in a ZigBee network, the device must be Included into the network by using a Primary Programmer/Remote. Please refer to the Remote Control instruction sheet for complete information.
-
Page 3: Troubleshooting
For "Leave" a network, please do the following instruction: Pressed Join/Leave button for 3 seconds to let the SZ-BSW01 be deleted from the ZigBee Coordinator. If the SZ-BSW01 has been deleted successfully, the LED will be on for 1 second and then off. -
Page 4: Fcc Statement
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.