Advertisement
手持花洒渊10冤的限流器不可取出遥
取出软管(12)一端接头内的垫片遥
将滤网垫片渊11冤放入软管接头内袁
将毡垫渊13冤放入手持花洒内袁将手
持花洒旋紧到软管上袁软管另一端
连接水源遥
把花洒挂在花洒托架渊9冤上遥
旋转手持花洒头部可以获得不同
水流方式,见右图遥
喷孔杂质或结垢会导致水流变
形袁流量变小遥 打开水源袁用力按
压或摩擦橡胶喷孔袁去除杂质或
水垢遥
拆下手持花洒渊10冤遥 先将滤网垫片
渊11冤和毡垫渊13冤从手持花洒中依
次取出遥 用热醋清洗滤网垫片上的
滤网袁清洗垫片滤网和毡垫遥 重新
将毡垫和滤网垫片装入手持花洒遥
重新装回手持花洒遥
1119910-2-A
10
13
12
11
雨淋式
激射式
Koverage
Kurrent
风暴式
云雾式
Komotion
Kotton
10
13
11
Don't remove the regulator of handspray
(10). Remove the washer from one
connector of the hose(12). Put the screen
washer(11) into the shower hose
connector, put the filter(13) into the
handspray, screw the handspray to the
shower hose. Connect another end of
shower hose to the water supply.
Hang the handspray on the handspray
holder(9).
Rotate the head of the handspray to
change the spray patterns as shown.
Any debris or mineral build-up may cause
the flow stream to become distorted or
reduce the flowrate. To remove the debris
or mineral build-up, run water through the
handspray, firmly press or rub your finger
back and forth across the rubber nozzles.
Remove the handspray(10). Take out the
screen washer(11) and the filter(13) from
the handspray. Clean the filters of the
screen washer by soaking them in warm
vinegar. Clean the screen washer and
filter. Reinstall the filter and screen
washer into the handspray. Reinstall the
handspray.
Advertisement
