Advertisement
根据安装尺寸和胀塞渊1冤直径在墙
面适当高度钻两个孔袁距离 711 毫
米遥 将胀塞分别塞入孔中袁用自攻
螺钉渊3冤安装支撑柱渊2冤遥 将滑杆
渊4冤靠在支撑柱上袁调整支撑柱使弧
形缺口紧贴滑杆遥 拿走滑杆袁锁紧
螺钉固定支撑柱遥
将销渊8冤旋入支撑柱袁用一字螺丝刀
锁紧遥
将锁紧组件渊5冤的孔与滑杆渊4冤的孔
对齐装入遥 如需要袁用螺丝刀调节
滑杆两端锁紧件的位置遥
将销与锁紧组件及滑杆的孔对齐遥
轻轻推滑杆袁将销插入滑杆及锁紧
组件袁直到滑杆与支撑柱贴紧遥 锁
紧锁紧组件上的紧定螺钉渊6冤固定
滑杆遥
花洒托架渊9冤锥孔大端朝上遥
将盖渊7冤扣到滑杆两端遥
按住花洒托架的簧片上下滑动袁可
调节托架位置遥
1119910-2-A
3
1
2
9
2
簧片
Pinch cock
4
5
6
8
7
簧片
Pinch cock
Drill holes according to the rough-in
dimensions and diameter of the anchors
(1) at the proper position on the finished
wall, distance 711mm. Press the anchors
into the holes. Connect the mounting
posts(2) by the self-tapping screws(3).
Hold the slide bar(4) up against the posts.
Adjust the posts until the slide bar fits
snug against the curved cutout of the
posts. Take away the slide bar. Tighten
the screws to secure the posts.
Thread the pins(8) into the mounting
posts. Tighten with a flat-blade
screwdriver.
Line up the holes in the lock assemblies
(5) with the holes in the slide bar(4). If
needed, use a screwdriver to adjust the
position of the locks at each end of the
slide bar.
Align the pins with the holes in the slide
bar and lock assemblies. Gently press the
slide bar against the posts, inserting the
pins, until the slide bar fits snug against
the posts. Secure the slide bar by
tightening the setscrew(6) of lock
assemblies.
The large side of inner taper for
handshower holder(9) faces up.
Press the caps(7) onto each end of the
slide bar.
The height of handshower holder can be
adjusted by pressing the pinch cock and
sliding up and down.
Advertisement
