Cleaning The Appliance - Silvercrest SDBS 2400 A1 Operating Instructions Manual

1) Switch the appliance off using the On/Off button t and allow it to cool
down.
2) Remove the power plug from the mains power socket.
3) Remove the iron from the base station and put it to one side.
4) Open the shaft cover 7.
CAUTION
Damage to the appliance!
5) Pull the limescale filter 8 upwards out of the limescale filter shaft.
6) Place the new limescale filter 8 in the limescale filter shaft and press it down
until it is firmly seated.
7) Close the shaft cover 7.
8) Insert the plug into a mains power socket and switch on the appliance using
the On/Off switch t.
9) Press the "reset" button r for about 3 seconds. The indicator lamp
goes out.
You have now completed replacement of the limescale filter 8.

Cleaning the appliance

♦ Clean the iron surfaces and the base station using only a soft, slightly moist
cloth.
Clean the sole of the iron 6 with a soft moist cloth. Ensure that the sole of
♦
the iron 6 is not scratched.
Pour the residual water in the water tank 0 into a basin. To do this, put the
♦
iron down to one side and open the water tank filler cap 9.
♦ The appliance must be completely dry before further use.
SDBS 2400 A1
Never pour water into the limescale filter shaft!
GB │ IE │ NI │ CY
│
e
15 ■