Handling And Use; Before First Use; Filling The Water Tank - Silvercrest SDBS 2400 A1 Operating Instructions Manual

Handling and use

This section provides you with important information on handling and using the
appliance.
Before first use
Clean the sole of the iron 6 using a slightly moist cloth.
♦
♦ To remove any leftover production residues, iron an old, clean cloth a few times.

Filling the water tank

NOTE
Use only tap water or distilled water.
If the mains water in your location is rated as hard, it is recommended that you
mix the mains water with some distilled water. Otherwise limescale deposits
can adversely affect the appliance functions.
Mix the tap water with distilled water in accordance with the following table:
The water hardness level can be queried at your local water works.
Do not add water with any additives (such as starch, perfume, softeners or
other chemicals) to the water tank 0. The appliance could be damaged,
since residues can form in the steam chamber. These residues can soil the
goods being ironed if they are deposited through the steam openings.
1) Disconnect the plug from the mains socket.
2) Open the water tank filler cap 9.
This is marked with the symbol:
3) Fill the water tank 0. Do not fill above the MAX marking in the water tank 0.
4) Close the water tank filler cap 9.
NOTE
Do not tip or swivel the steam station when the water tank 0 is full. If you
►
do, water may be discharged from the filler opening.
5) Insert the plug into a mains power socket.
■ 10 │ GB │ IE │ NI │ CY
Water hardness
very soft/soft
medium
hard
very hard
Ratio of distilled water to
tap water
-
1:1
2:1
3:1
.
SDBS 2400 A1