Operating The "Oyster® Tv; Initial Setup; General Tv Settings - Ten-Haaft Oyster TV 19" Operator's Manual

3. OPERATING THE "OYSTER® TV"

3.1 Initial setup

Your Oyster TV set is configured at the factory with a standard channel list and, depending on specifications,
with favourite lists. (See section 3.5, Favourite lists (satellite TV) if you wish to create further lists.) Should any
channels be missing or if you wish to add further channels, you need to start the automatic channel scan.
Select a signal source. If using a ten Haaft satellite system, DVB-S must be selected.
Press to open the signal input menu.
SOURCE
Press to select the input, then press
OK
system will automatically switch back to the current signal source after a few seconds.
Press to exit the menu. The following signal inputs can be selected. Press the corresponding buttons on the
EXIT
remote control:
• Digital TV
• Satellite TV
• AV
• HDMI 1
• HDMI 2
• USB
14
to confirm. If no source is selected using the
OK
3. OPERATING THE "OYSTER® TV"

3.2 General TV settings

TV SETUP MENU
The setup menu is used to adjust the TV set to your personal preference.
• Press the
• Press
• Press Exit or Setup to exit the setup menu.
IMAGE
In this menu you can change the picture settings of the "Oyster
button, the
SOUND
In this menu you can change the sound settings of the "Oyster
button to select a display menu.
SETUP
to navigate in the menus.
TV". The following settings are available:
®
® TV". The following settings are available:
15